• Manufactured from 100% recycled, plastic
• Features 8 x highly reflective Yellow chevrons fixed in place with an epoxy adhesive
• Flexible enough to contour to the ground level, unlike hard extrusion moulded Wheel Stops
• Clean Pre-drilled 14mm fixing holes for ease of installation
• Flexible and conforms to any concrete or asphalt surface
• Resistant to extreme temperatures, UV light, oils, damage, and moisture
• Will not crack, chip, rust, crumble, or erode in any weather conditions
• Perfect for permanent or temporary installations
• Comes with a three year warranty

‍

To install Wheelstops for your location, we strongly recommend you use a qualified, local wheel stop installer or line maker. If you are only buying / installing one or two wheel stops, you can follow these steps below if a DIY install is necessary:

‍

1. Clean surface as much as possible. Ensure that all road stones and other small objects are clear of the surface area.
2. When installing multiple wheel stops, run a sting line and pre-mark all of your drill holes.
3. First pilot drill the fixing holes, then turn over the wheel stop and finish drilling to the required depth for your fixing.
4. Vacuum and clear the surface area of all cement dust and other particles.
5. For best results, apply a strong 2-part epoxy adhesive to the bottom of the wheel stop before setting down on the surface.
6. Screw/bolt in the desired fixing, following best guidelines for that particular wheel stop fixing.